EdSets High Fidelity Intercom Headsets
Topic Information
 Added by  pmuscutt (Guest)
 Added  4 Jan 2008, 12:16 PM
 Last Updated  6 Aug 2008, 8:06 AM
 Topic  Edsets dynamic mic and the J&M2003
I guess I'm the first on this forum category,
 
I know Edsets has the adapter to drop J&M from 6 pin to 5 pin because of the dynamic mic. Does anyone have experience with Edsets and J&M2003? I'm a little concerned about the mics ability to drive the radio sufficiently due to the dynamic mic spec at -56dB and from what I understand condensors are at about -35db.
Message
Nickname *
Your Email Address *
Message *
Type the four colored numbers in the picture if you are a real person. *  
pmuscutt (Guest)
I guess I'm the first on this forum category,
 
I know Edsets has the adapter to drop J&M from 6 pin to 5 pin because of the dynamic mic. Does anyone have experience with Edsets and J&M2003? I'm a little concerned about the mics ability to drive the radio sufficiently due to the dynamic mic spec at -56dB and from what I understand condensors are at about -35db.
 
kinch (Guest)
I guess I'm the first on this forum category,
 
I know Edsets has the adapter to drop J&M from 6 pin to 5 pin because of the dynamic mic. Does anyone have experience with Edsets and J&M2003? I'm a little concerned about the mics ability to drive the radio sufficiently due to the dynamic mic spec at -56dB and from what I understand condensors are at about -35db.
 
kinch (Guest)
I guess I'm the first on this forum category,
 
I know Edsets has the adapter to drop J&M from 6 pin to 5 pin because of the dynamic mic. Does anyone have experience with Edsets and J&M2003? I'm a little concerned about the mics ability to drive the radio sufficiently due to the dynamic mic spec at -56dB and from what I understand condensors are at about -35db.
 
kinch (Guest)
Looking for replacement microphones compatable with 2005 K1200lt "Voice II" intercom. Have tried several "compatable type" with limited success. Voice II seems to be configured for
electret mics with a bias voltage of 12 vdc, however I can't seem to find an electret with enough output ( 200 mv & up).
I'm open for suggestions!
 

EdSets, LLC
2416 Passage Key Tr., Xenia OH 45385
(937)271-4077(Call 9-5 Eastern Standard Time)
Copyright 2009, All rights Reserved
ViArt - PHP Shopping Cart